WHATSAPP : +86-180 1870 0287
CONTACT PERSON : Eminence
TEL : 0086-755-29361324
E-MAIL : firstname.lastname@example.org
OFFICE ADD : 17F, Block A, Baoxin Technology Park, Fenghuang Street, Guangming District, Shenzhen.
Runfree is a professional disposable pod supplier and manufacturer in China, specializing in wholesale vape pens.
There are many factors that affect the lack of smoke. After the atomizer is installed, let it stand still for 5 minutes before pumping. If it still cannot produce smoke, it is the problem of the atomizing core. Replace the atomizing core and do it again as before. , if it still doesn’t work, it means that the atomizer and the battery are not in good contact.
E-cigarettes have no smoke, there may be the following reasons:
What's the matter with e-cigarettes not smoking?
1. Check to see if e-liquid has been added to the atomizer or if there is too little e-liquid.
2. Check whether the battery and atomizer are connected properly.
3. Check to see if the battery power has been turned on.
4. During normal use, it is necessary to press the button to produce smoke normally. Check whether the operation is correct
5. If there is no problem with the above 4 points, then there may be a problem with the atomizing core, and you need to contact customer service as soon as possible to solve it
6. If there is no problem with the atomizing core, then the main board of the battery is broken and needs to be repaired
Why can't e-cigarettes smoke?
1. It may be that the nebulizer is broken, and the nebulizer needs to be replaced.
2. It may be that there is no e-liquid, just add some e-liquid.
3. If the indicator light of the charger is not on, but the light of the battery is on, it means that the indicator light of the charger is broken. If it is not on, it means that the charger is broken. If it lights up, it means the battery is bad.
What's the matter if the e-cigarette still doesn't smoke after refueling?
It is estimated that the connection between the atomizer and the battery rod is not in good contact. The following steps are recommended:
1. To open the cigarette holder, first rotate the thread to pull up or insert vertically, and do not tilt it;
2. Do not add e-liquid from the small hole in the middle of the atomizer, the middle vent hole is not the place for refueling (see the picture above for the correct method of oil filling);
3. E-cigarettes are based on the principle of high-temperature heating. Condensation will be generated on the top of the cigarette rod. When charging, it must be wiped with a paper towel;
4. In addition to the frequency of use, the service life of the nebulizer has a very important relationship with the habit of use. Keep the interval between each use for 5 seconds. 5. The service life can be extended if it is above;
6. The built-in lithium battery of the device has no memory activation, just fully charge it;
7. The device is controlled by pressing and sucking. Turn on the device, press it 5 times, press and hold the button of the device when using it, and release the button without diluting it. After you don't smoke, press it 5 times to turn it off.
The normal use steps of electronic cigarettes
1. Connect the nebulizer
2. Fill the atomizer with oil, pay attention to the method of oil injection, do not add oil to the central vent hole, and add oil from the outside of the inner wall of the atomizer.
3. Wait for about 5 minutes after refueling.
4. Press the power button of the main unit 5 times continuously within three seconds to turn on the machine.
5. Adjust the air flow of the air inlet.
6. Press and hold the switch when pumping.